Installation Guide |
|
Quality engineering for super reliability and easy installation! Over 7,000,000 feet of the SquidGee Dry System has been used to dry up thousands of wet, leaky basements. Yours can be next! Follow this installation guide carefully and you'll soon be enjoying a dry basement! |
13. Install Corners Last |
|
 |
Inside corners are easy to install when dropped down from the top. Use a coarse sandpaper to rough up any vinyl to vinyl surfaces. Apply SealOnce on both main sections and the bottom of the corner piece. |
14. Seal Edges of the Corners |
|
 |
Sealing the edges of the Corners and caulking the bottom will insure there are no leaks. |
15. Installing an End Cap |
|
 |
Apply SealOnce across the bottom and up the wall and down the edge of the baseboard. Set end cap in place and caulk all joining surfaces again. |
16. Directing Water to a Floor Drain |
|
 |
Be sure and check your local building codes before draining to a floor drain. |
17. Directing Water to a Sump Pump |
|
 |
Draining to a Sump Pump in most communities is the proper method of disposing of ground water. |
18. Paneling the Walls |
|
 |
Attach your 2"x 2" base plate to the wall 1/2" above the SquidGee Dry System. Run all firring strips down to the base plate. Panel only down to the base plate. Attach the base to the base plate to cover the SquidGee Dry System. |
|
|
|
|
